- 您现在的位置：买卖IC网 > Sheet目录527 > SX1210I084T (Semtech)IC SINGLE-CHIP RECEIVER 32-TQFN
SX1210
ADVANCED COMMUNICATIONS & SENSING
In OOK mode, the RSSI evaluates the signal strength by sampling I(t) and Q(t) signals 16 times in each period of
the chosen IF2 frequency (refer to section 3.3.1). In FSK mode, the signals are sampled 16 times in each Fdev
period, Fdev being the frequency deviation of the companion transmitter. An average is then performed over a
sliding window of 16 samples. Hence, the RSSI output register RXParam_RSSI is updated 16 times in each Fdev
or IF2 period.
The following settings should be respected:
FSK Mode: Ensure that the Fdev parameter (as described in MCParam_Fdev) remains consistent with the
actual frequency deviation of the companion transmitter.
OOK reception: Ensure that the Fdev parameter (as described in MCParam_Fdev) is equal with the frequency
of I(t) and Q(t) signals, i.e. the second Intermediate Frequency, IF2, of the receiver (Note that this equals Fo,
the center frequency of the polyphase filter).
3.3.7.3. Dynamic Range
The dynamic range of the RSSI is over 70 dB, extending from the nominal sensitivity level. The IF gain setting
available in MCParam_IF_gain is used to achieve this dynamic range:
RSSI Response
180
160
140
120
100
80
60
40
20
0
-120
-100
-80
-60
-40
-20
0
Pin [dBm]
IF_Gain=00
IF_Gain=01
IF_Gain=10
IF_Gain=11
Figure 14: RSSI Dynamic Range
The RSSI response versus input signal is independent of the receiver filter bandwidth. However in the absence of
any input signal, the minimum value directly reflects upon the noise floor of the receiver, which is dependant on the
filter bandwidth of the receiver.
3.3.7.4. RSSI IRQ Source
The SX1210 can also be used to detect a RSSI level above a pre-configured threshold. The threshold is set in
IRQParam_RSSI_irq_thresh and the IRQ status stored in IRQParam_RSSI_irq (cleared by writing a “1”).
An interrupt can be mapped to the IRQ0 or IRQ1 pins via bits IRQParam_Rx_stby_irq0 or
IRQParam_Rx_stby_irq1. Figure 15 shows the timing diagram of the RSSI interrupt source, with
IRQParam_RSSI_irq_thresh set to 28.
Rev 2– Sept 8 , 2008
th
Page 21 of 73
www.semtech.com
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
SX1211SK915
KIT STARTER FOR SX1211 915MHZ
SX1211SKA915
KIT STARTER FOR SX1211 915MHZ
SX1223SK868
KIT STARTER FOR XE1223 868MHZ
SX1231-31SKB915
TVS
SX1240SKA433
TVS
SX1701BI085TRT
IC AMP 2.5GHZ 5.3V 16-MLPQ
TA002-10002
LED HEATSINK W/FAN 12V 40X10MM
TC620HEPA
IC TEMP SNSR 5V DUAL TRIP 8-DIP
相关代理商/技术参数
SX1210I084TRT
制造商:Semtech Corporation 功能描述: 制造商:Semtech Corporation 功能描述:IC SINGLE-CHIP RECEIVER 32-TQFN 制造商:Semtech Corporation 功能描述:SX1210 Series 863 to 960 MHz 3 V 200 kbps Ultra Low Power Receiver - TQFN-32
SX1211
制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Lowest Power Integrated UHF Transceiver Short Range Devices
SX1211_08
制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Ultra-Low Power Integrated UHF Transceiver
SX1211-11SKA868
功能描述:KIT STARTER FOR SX1211 868MHZ RoHS:是 类别:RF/IF 和 RFID >> RF 评估和开发套件，板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
SX1211-11SKA915
功能描述:KIT USB FOR SX1211 TXRX 915MHZ RoHS:是 类别:RF/IF 和 RFID >> RF 评估和开发套件，板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
SX1211I084T
制造商:Semtech Corporation 功能描述:
SX1211I084TRT
功能描述:IC SNGL-CHIP TXRX 32-TQFN RoHS:是 类别:RF/IF 和 RFID >> RF 收发器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:30 系列:- 频率:4.9GHz ~ 5.9GHz 数据传输率 - 最大:54Mbps 调制或协议:* 应用:* 功率 - 输出:-3dBm 灵敏度:- 电源电压:2.7 V ~ 3.6 V 电流 - 接收:* 电流 - 传输:* 数据接口:PCB，表面贴装 存储容量:- 天线连接器:PCB，表面贴装 工作温度:-25°C ~ 85°C 封装/外壳:68-TQFN 裸露焊盘 包装:管件
SX1211I084TRT
制造商:Semtech Corporation 功能描述:GPSS WL SKU APP1